Take your deck from wood to wow with a composite decking makeover – Home Improvement Blogs

(BPT) – Take into account this — for the exact amount of time and vitality necessary to strip, sand and stain a wooden deck, you could replace all those boards with composite decking and in no way yet again have to fear about upkeep. Built for utmost longevity and minimum maintenance, wood-alternative decking, like Trex, is resistant to fading, staining, scratching and mildew, and just an occasional soap-and-drinking water cleansing is all it normally takes to retain a “like-new” overall look for many years.

Resurfacing a deck is a doable Diy challenge that can be finished in a weekend or two with just a minimal know-how and the enable of a handful of friends. Simply just follow these measures from the gurus at Trex Academy to give your aged wood deck a makeover with higher-effectiveness, stress-free of charge composite decking.

1. Take out old deck boards

Start out by removing any railing and prying up the present deck boards. Depart the substructure and framing in location.

2. Clean up the frame

Make certain that all fasteners and hardware have been eliminated from the leading of the deck body. If nails can not be taken out, bend the suggestions in excess of so they lie flat on the wood for safety. Remove any particles from the bays among joists to let air to move beneath the body.

3. Inspect the substructure

Test the beams and joists of the framing to make sure these foundational factors are absolutely free of rot and decay. Use a flathead screwdriver to probe for soft places. Mend or substitute any decayed or rotting framing ahead of continuing.

4. Secure joists and beams

For extra defense and to prolong the life of your deck, use protecting flashing tape, these types of as Trex Protect to the joists and beams of the substructure. This quick-to-use, self-adhesive tape will help to safeguard wood and metallic fasteners from dampness that can direct to rot, rust and decay.

5. Install new deck boards

Get started laying out the new composite deck boards commencing with the board farthest away from the residence. Be certain to closely adhere to the manufacturer’s directions for spacing to assure right air flow.

6. Shuffle the deck

Composite decking is built with random variation in hue from board to board. For the most natural-wanting outcomes, shuffle — or mix — the boards to build your wished-for glimpse. This can be completed by laying out a number of classes of boards and arranging them to your liking before setting up.

7. Body and end

Once the deck boards are in spot, use a circular saw to trim any overhang for clear, finished edges. Then re-connect railing factors or increase new railing paying out close awareness to the manufacturer’s installation guideline and nearby developing codes.

8. Beautify and get pleasure from!

Include furnishings and decorative factors to end matters off. Then, stage back again, admire your get the job done and get pleasure from your new, trouble-free of charge out of doors area.

For a lot more professional guidance and resources, like a action-by-action deck resurfacing online video, check out the Trex Academy segment of Trex.com.

Facebooktwitterredditpinterestmail